I think Freestyle is going to make a comeback.

[rockst*r]

I've also put a bearing spacer between the hanger and inside wheel bearing to push them way out. rockst*r might want to try that trick too. The fatter axle nuts don't crank down to the nylon with a bearing spacer there though.

I can only realistically fit 2 bearing spacers between the hanger and the inside wheel bearing...Those Royal trucks have incredibly tight tolerances on the axle!

[NoSwitch]

I've shuffled wheels and trucks around some after snapping the Street Lite. Anyway, ended up with some spare 4.25s so I started looking at other freestyle decks and really digging this Decomposed Signed Reggie Barnes. Looks totally sick. And Reggie's a North Kakalaki guy. Gonna put the trucks and some Slammers on it and hang it up. I feel good giving Decomposed some business right now. every little bit helps these local businesses.

[Rev J]

I wish I could Rep you for that.

Isn't Sean Burke from there too?

[NoSwitch]

She's here. Kinda lame to put Slammers on her but perfect width with no washers and strictly a wall hanger of course..

reggie barnes.jpgreggie barnes.jpg

[Rev J]

I got a 45 minute session in yesterday finally. between the virus, shit weather, exhaustion, etc I hadn't felt much like it. I worked on switchblades the problem I noticed was either pushing them too hard and over rotating, or not pushing hard enough and under rotating. I'm also getting a little stress crack near my back truck. I'll probably do a new setup when it gets really bad. I've already got a replacement deck and I've pretty much gotten my $32 out of the one I'm riding now.